Titlebook: Building Engineering Facing the Challenges of the 21st Century; Holistic Study from David Bienvenido-Huertas,Joaquín Durán-álvarez Book 20

Allodynia

Life-Repolyuse from the Laboratory to a Commercial Product as Part of the Circular Economy: The Entrreal market product in a fast and efficient way. The key aspect to reach the success was aligning the vast expertise of the Building Engineering Research Group (GIIE) from the University of Burgos, in the reuse of polyurethane foam waste with the involvement manufacturer of the new sustainable build

Calculus

Analytical and Experimental Study of Short Reinforced Concrete Beams Reinforced with CFRPe-point bending. Two types of carbon fibers were used: high modulus of elasticity and high strength. The beams have been evaluated analytically with two different procedures: (i) using a tie rod and tie-rod model, this procedure would be the indicated one since all regions are in D-zones and, (ii) u

贊美者

特征

Structural Condition Assessment Through the Optimal Combination of Different Non-destructive Techniqheir durability. In many cases, there is a tendency to do inspections using invasive or destructive techniques, which can be complex and costly. This study aims to demonstrate the effectiveness of the combined use of different non-destructive techniques and its applicability to structural inspection

聽覺(jué)

Impact of Environmental Conditions on Construction Materials Throughout Long-Term Surveys to Promoten the conservation of traditional building materials. Thus, this work aims to establish a relationship between environmental parameters (Temperature and Relative Humidity) and the preservation of plasterworks, wooden carpentries and ceilings, and tilings. Results will easily reveal which are the mos

可耕種

Study of the Deformation Capacity of Corroded Passive Rebarsonditions. The ductility requirements have increased significantly since the 1980s as a result of the increasing use of analysis procedures for reinforced concrete structures based on the limited redistribution of moments and the greater concern in the calculations of structures located in seismic z

卡死偷電

Building Engineering Facing the Challenges of the 21st Century978-981-99-2714-2Series ISSN 2366-2557 Series E-ISSN 2366-2565

REP

疲勞

https://doi.org/10.1007/978-981-99-2714-2Plaster mortars; Polyurethane foams; Carbon composites; Regenerative buildings; Building Information Mod

地名詞典

978-981-99-2716-6The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Singapor